Articles (18) Publications in which a researcher has participated View referenced research data.

in the year 2005 Remove filter
filter_list Type (aggr.) Articles from 2005 to 2005

2005

  1. Abnormal growth of TiB2 crystals during sintering of TiB2-Ni3(Al,Ti) cemented borides

    Metallurgical and Materials Transactions A: Physical Metallurgy and Materials Science, Vol. 36 A, Núm. 2, pp. 459-466

  2. Absence of one-to-one correspondence between elastoplastic properties and sharp-indentation load-penetration data

    Journal of Materials Research, Vol. 20, Núm. 2, pp. 432-437

  3. An adaptive feedforward amplifier under "Maximum output" control method for UMTS downlink transmitters

    IEEE Transactions on Microwave Theory and Techniques, Vol. 53, Núm. 8, pp. 2481-2485

  4. An integrated up-converter circuit in 0.8 μm SiGe technology for TV applications

    Microelectronics Journal, Vol. 36, Núm. 8, pp. 763-769

  5. Continuity-based interfacing of models for wastewater systems described by Petersen matrices

    Water Science and Technology, Vol. 52, Núm. 1-2, pp. 493-500

  6. Critical assessment of computational thermodynamics in the alloy design of PM high speed steels

    Scripta Materialia, Vol. 53, Núm. 3, pp. 287-292

  7. Enhanced implementation of blind carrier frequency estimators for QPSK satellite receivers at low SNR

    IEEE Transactions on Consumer Electronics, Vol. 51, Núm. 2, pp. 442-448

  8. HIP after sintering of ultrafine WC-Co hardmetals

    International Journal of Refractory Metals and Hard Materials, Vol. 23, Núm. 3, pp. 193-198

  9. Medida de LA DUREZA de sólidos mediante nanoindentación

    Boletín de la Sociedad Española de Cerámica y Vidrio, Vol. 44, Núm. 5, pp. 259-264

  10. On the design of receiver root-raised cosine FIR filters in high interference scenarios

    IEEE Transactions on Consumer Electronics, Vol. 51, Núm. 4, pp. 1104-1109

  11. Optimización del diseño, operación y control de las EDAR utilizando modelos matemáticos y herramientas de simulación

    Tecnología del agua, Núm. 266, pp. 74-79

  12. Simulation of the microstructural evolution during liquid phase sintering using a geometrical Monte Carlo model

    Modelling and Simulation in Materials Science and Engineering, Vol. 13, Núm. 7, pp. 1057-1070

  13. Some design criteria for UWB planar monopole antennas: Application to a slotted rectangular monopole

    Microwave and Optical Technology Letters, Vol. 46, Núm. 1, pp. 6-11

  14. Strain rate sensitivity of superplastic inconel 718

    Materials Transactions, Vol. 46, Núm. 7, pp. 1711-1719

  15. Study by EBSD of the development of the substructure in a hot deformed 304 stainless steel

    Materials Science and Engineering A, Vol. 394, Núm. 1-2, pp. 445-454

  16. Synthesis and biological evaluation of new symmetrical derivatives as cytotoxic agents and apoptosis inducers

    Bioorganic and Medicinal Chemistry, Vol. 13, Núm. 6, pp. 2031-2044

  17. Tensiones residuales generadas en acero F-522 por distintos tipos de mecanizado

    Revista de metalurgia, Vol. 41, Núm. 4, pp. 266-279

  18. Thermal conductivity microsensor for determining the Methane Number of natural gas

    Sensors and Actuators, B: Chemical, Vol. 110, Núm. 2, pp. 181-189