Publicacions en què col·labora amb Shandra Sáinz Rodríguez (18)

2020

  1. Effect of low-pressure carburizing and plasma nitriding on mechanical properties and fatigue endurance limits of low alloy sintered steels

    Powder Metallurgy, Vol. 63, Núm. 2, pp. 75-79

  2. Experimental study of the surface characteristics of electron beam melted Ti-6Al-4V and its improvement

    Euro PM 2018 Congress and Exhibition

  3. Microstructural development and effect of Cu/Ni/C interactions on dimensional changes and hardenability during sintering of PM steels

    Euro PM 2018 Congress and Exhibition

2019

  1. Microstructures and mechanical properties of Ti6Al4V parts fabricated by EBM: Effects of manufacturing defects and thermal treatment conditions

    Euro PM 2019 Congress and Exhibition

2016

  1. Dilatometric analysis of pre-alloyed high hardenability PM steels containing elemental Cu additions

    World PM 2016 Congress and Exhibition

  2. Enhanced control of dimensional change and mechanical properties of Fe-Cu-C PM steels under optimized sintering cycle

    World PM 2016 Congress and Exhibition

  3. Low pressure carburizing for steel components subjected to wear: A comparison against plasma nitriding

    World PM 2016 Congress and Exhibition

  4. Selective laser melting of steels-based metal matrix composites with ceramic reinforcement

    World PM 2016 Congress and Exhibition

  5. Sintered Mn-containing steels for highperformance applications

    International Journal of Powder Metallurgy

2015

  1. Controlled shrinkage of low alloy PM steels during LPS

    Advances in Powder Metallurgy and Particulate Materials - Proceedings of the 2015 International Conference on Powder Metallurgy and Particulate Materials, PowderMet 2015

  2. Improved sintering of Fe-Cu-C PM Steels

    Proceedings Euro PM 2015: International Power Metallurgy Congress and Exhibition

  3. Microstructural development and effect of different Cu/C contents on dimensional changes during sintering of PM steels

    Powder Metallurgy, Vol. 58, Núm. 5, pp. 328-334

  4. Sintered Mn containing steels for high performance applications

    Advances in Powder Metallurgy and Particulate Materials - Proceedings of the 2015 International Conference on Powder Metallurgy and Particulate Materials, PowderMet 2015

2014

  1. Microstructural development and effect of different Cu/C contents on dimensional changes during sintering of PM steels

    Euro PM 2014 Congress and Exhibition, Proceedings

2013

  1. Influence of sintering cycle and chemical composition on the amount of martensite obtained after cooling of PM nickel steels

    International Powder Metallurgy Congress and Exhibition, Euro PM 2013

2012

  1. Lean Cr iron powders for obtaining high performance PM steel grades

    Powder Metallurgy, Vol. 55, Núm. 2, pp. 92-94

  2. The master alloy concept and its consequences

    Advances in Powder Metallurgy and Particulate Materials - 2012, Proceedings of the 2012 International Conference on Powder Metallurgy and Particulate Materials, PowderMet 2012

2011

  1. Lean cr-containing powders for obtaining high performance PM steel grades

    Proceedings of the Euro International Powder Metallurgy Congress and Exhibition, Euro PM 2011