Centro / Instituto vinculado a la Universidad de Navarra
Asociación Centro Tecnológico Ceit (CEIT)
Artigos (36) Publicacións nas que participase algún/ha investigador/a
2011
-
A 16-kV HBM RF ESD protection codesign for a 1-mW CMOS direct conversion receiver operating in the 2.4-GHz ISM band
IEEE Transactions on Microwave Theory and Techniques, Vol. 59, Núm. 9, pp. 2318-2330
-
A comparison of the effects of multi-wall and single-wall carbon nanotube additions on the properties of zirconia toughened alumina composites
Carbon, Vol. 49, Núm. 5, pp. 1599-1607
-
A knowledge-based control system for air-scour optimisation in membrane bioreactors
Water Science and Technology, Vol. 63, Núm. 9, pp. 2025-2031
-
AAL for supporting elderly
2011 IST-Africa Conference Proceedings, IST 2011
-
ADD CONTROL: Advanced control solutions for waste water treatment
Reviews in Environmental Science and Biotechnology, Vol. 10, Núm. 1, pp. 3-7
-
An optimization method for overdetermined kinematic problems formulated with natural coordinates
Multibody System Dynamics, Vol. 26, Núm. 4, pp. 397-410
-
Analytical calculation of the flux distribution and demagnetization in spoke interior permanent-magnet machines with non-magnetic shaft
International Review of Electrical Engineering, Vol. 6, Núm. 3, pp. 1228-1238
-
Assessment of the influence of thermal pre-treatment time on the macromolecular composition and anaerobic biodegradability of sewage sludge
Bioresource Technology, Vol. 102, Núm. 2, pp. 660-666
-
Automatic characterisation of primary, secondary and mixed sludge inflow in terms of the mathematical generalised sludge digester model
Water Science and Technology, Vol. 64, Núm. 3, pp. 557-567
-
Battery response analyzer using a high current DC-DC converter as an electronic load
Renewable Energy and Power Quality Journal, Vol. 1, Núm. 9, pp. 611-615
-
CALHIDRA 3.0 - New software application for river water quality prediction based on RWQM1
Environmental Modelling and Software, Vol. 26, Núm. 7, pp. 973-979
-
Combined model to describe both the mechanical and microstructural transients under a reversal of strain
Metallurgical and Materials Transactions A: Physical Metallurgy and Materials Science, Vol. 42, Núm. 9, pp. 2633-2642
-
Comparative analysis of QCM and SPR techniques for the optimization of immobilization sequences
Sensors and Actuators, B: Chemical, Vol. 155, Núm. 2, pp. 667-672
-
Comparison of the oxidation behaviour of WC-Co and WC-Ni-Co-Cr cemented carbides
Corrosion Science, Vol. 53, Núm. 9, pp. 2754-2760
-
Consolidation of (Ti,Mo)(C,N)-Ni cermets by glass encapsulated hot isostatic pressing
Materials Science and Engineering A, Vol. 528, Núm. 13-14, pp. 4453-4461
-
Dependence of the order and crack density of polystyrene opals on volume fraction, humidity and temperature
Crystal Research and Technology, Vol. 46, Núm. 10, pp. 1044-1050
-
Diffusional Monte Carlo model of liquid-phase sintering
Mathematics and Computers in Simulation, Vol. 81, Núm. 11, pp. 2564-2580
-
Effect of austenite microstructure and cooling rate on transformation characteristics in a low carbon Nb-V microalloyed steel
Materials Science and Engineering A, Vol. 528, Núm. 6, pp. 2559-2569
-
GMR sensors: Magnetoresistive behaviour optimization for biological detection by means of superparamagnetic nanoparticles
Biosensors and Bioelectronics, Vol. 26, Núm. 8, pp. 3705-3709
-
HF Antenna design optimization for railway spot signalling systems
Microwave and Optical Technology Letters, Vol. 53, Núm. 12, pp. 2742-2746