Publicaciones (52) Publicaciones en las que ha participado algún/a investigador/a

2005

  1. A 3.2-GHz fully integrated low-phase noise CMOS VCO with self-biasing current source for the IEEE 802.11a/hiperLAN WLAN standard

    Proceedings of SPIE - The International Society for Optical Engineering

  2. A SU-8 microfluidic total analysis system integrating silicon photodiodes and buried waveguides

    2005 Spanish Conference on Electron Devices, Proceedings

  3. A new technique for the characterization of the adhesion in integrated circuit interconnect structures

    11th International Conference on Fracture 2005, ICF11

  4. A new technique for the characterization of the adhesion in integrated circuit interconnect structures

    Materials Research Society Symposium Proceedings

  5. Abnormal growth of TiB2 crystals during sintering of TiB2-Ni3(Al,Ti) cemented borides

    Metallurgical and Materials Transactions A: Physical Metallurgy and Materials Science, Vol. 36 A, Núm. 2, pp. 459-466

  6. Absence of one-to-one correspondence between elastoplastic properties and sharp-indentation load-penetration data

    Journal of Materials Research, Vol. 20, Núm. 2, pp. 432-437

  7. Ag/AgI quasi-reference microelectrodes

    2005 Spanish Conference on Electron Devices, Proceedings

  8. Ag/Agl quasi-reference microelectrodes

    2005 Spanish Conference on Electron Devices, Proceedings

  9. An adaptive feedforward amplifier under "Maximum output" control method for UMTS downlink transmitters

    IEEE Transactions on Microwave Theory and Techniques, Vol. 53, Núm. 8, pp. 2481-2485

  10. An integrated up-converter circuit in 0.8 μm SiGe technology for TV applications

    Microelectronics Journal, Vol. 36, Núm. 8, pp. 763-769

  11. Application of coercive field measurements to the evaluation of recovery and recrystallization in cold rolled Interstitial Free (IF) steel

    Materials Science Forum

  12. Calculation of nano-crystalline copper toughness using the embedded atom method

    11th International Conference on Fracture 2005, ICF11

  13. Collision problem: Characteristics for a Taxonomy

    Proceedings of the International Conference on Information Visualisation

  14. Continuity-based interfacing of models for wastewater systems described by Petersen matrices

    Water Science and Technology, Vol. 52, Núm. 1-2, pp. 493-500

  15. Critical assessment of computational thermodynamics in the alloy design of PM high speed steels

    Scripta Materialia, Vol. 53, Núm. 3, pp. 287-292

  16. Effect of the strain reversal on grain boundary character and substructure development on a hot worked austenitic stainless steel

    Materials Science Forum

  17. End-fire coupling of a SU-8 waveguide to a silicon mesa photodiode: Integrability in an optical analysis microsystem

    Sensors and Actuators, A: Physical

  18. Enhanced implementation of blind carrier frequency estimators for QPSK satellite receivers at low SNR

    IEEE Transactions on Consumer Electronics, Vol. 51, Núm. 2, pp. 442-448

  19. Erratum: Absence of one-to-one correspondence between elastoplastic properties and sharp-indentation load-penetration data (Journal of Materials Research (2005) vol. 20 (432))

    Journal of Materials Research

  20. Factors limiting the achievable ferrite grain refinement in hot worked microalloyed steels

    Materials Science Forum